Attach A Monitor To The Spring Arm - StarTech ARMPIVWALL Guia Del Usuario

Attach a monitor to the spring arm

Caution! To prevent scratching, you should handle the surface of the monitor with
care when you attach it to the spring arm.
Warning! Make sure that the weight of the monitor doesn't exceed the weight
capacity of this product. If you exceed the weight capacity, you might experience
personal injury or damage to the product. This product can support the
following weight: 4.4 lb. (2 kg) to 19.8 lb. (9 kg).
1. Do one of the following:
• If the VESA mount sits flush against the installation surface on the monitor,
insert the four M4x12 mm screws (7) through the VESA mount on the
spring arm (1) and into the mounting holes on the back of the monitor.
Use a Phillips screwdriver to tighten the screws. (figure 3)
• If the VESA mount doesn't sit flush against the installation surface on the
monitor, you need to use the provided spacers. Insert the four M4x25 mm
screws (8) through the VESA mount on the spring arm (1), into the four spacers
(11), and into the mounting holes on the back of the monitor.
Use a Phillips screwdriver to tighten the screws. (figure 4)
figure 3
M4x12 mm screw
Instruction manual
VESA mount
7
Monitor