Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
&
1.
3.
4.
5.
6.
WARNING:
TO AVOID SERIOUS
iNJURY, BEFORE PERFORMING
ANY SERVICE OR
ADJUSTMENTS:
Depress
clutch/brake
pedal fully and set parking
brake.
Place
attachment
clutch
in "DISENGAGED"
position.
Turn ignition
key to "STOP"
and remove
key.
Make sure the blades
and all moving
parts have completely
stopped.
Disconnect
spark plug wire from spark plug and place
wire where
it cannot
come
in contact
with plug.
TO REMOVE MOWER
1.
Place
attachment
clutch
in "DISEN-
GAGED"
position.
2.
Lower
attachment
lift lever to its lowest
position.
3.
Disengage
belt tension
rod (K) from lock
bracket
(L).
_,
CAUTION:
Belt
tension
rod is spring
loaded.
Have a tight grip on rod and release
slowly.
4.
Remove
mower
belt from electric
clutch
pulley
(M).
5.
Disconnect
front
link
(E) from
mower
-
remove
retainer
spring
and washer.
6.
Goto either side of mower and disconnect
mower
suspension
arm (A) from
chas-
sis and rear lift link (C) from rear mower
bracket
(D) - remove
retainer
springs
and
washers.
7.
Go to other side of mower and disconnect
the suspension
arm and rear lift link.
CAUTION:
After rear lift links are discon-
nected,
the attachment
lift lever will be spring
loaded.
Have
a tight grip on lift lever when
changing
position
of the lever.
8.
From
right
side
of mower,
disconnect
anti-sway
bar (S) from
right rear mower
bracket
(D) - remove
retainer
spring
and
washer
and pull mower
toward
you until
the bar falls from the hole in bracket.
9.
Turn tractor
steering
wheel
to the left as
far as it will go.
10. Slide mower
out from under right side of
tractor.
TO INSTALL
MOWER
Follow
procedure
described
in "INSTALL
MOWERAND
DRIVE
BELT" in theAssembly
section
of this manual.
26
Publicidad
Tabla de contenido
