Electrical Specifications
1. All wiring must comply with local and national
electrical codes and be installed by a qualified
electrician. If you have any questions regarding the
following instructions, contact a qualified electrician.
2. Check available power supply and resolve any wiring
problems BEFORE installation and operation of this
unit.
3. For your safety and protection, this unit is grounded
through the power cord plug when plugged into a
matching wall outlet. If you are not sure whether the
wall outlets in your home are properly grounded,
please consult a qualified electrician. DO NOT USE
PLUG ADAPTERS OR EXTENSION CORDS.
4. The manufacturers nameplate is located on the rear
(back) wall of the cabinet. The nameplate contains
electrical and other technical data specific to this unit.
5. To avoid the possibility of personal injury, always
disconnect the power supply before attempting to
clean and/or service the unit.
Unit Specifications:
Dehumidifying Capacity
Electrical Requirements
Power Input (watts)
Rated Amperage
• Dehumidifying
• Heating
Air Flow Circulation - High /Low Fan Speed
Type of Refrigerant
Water Tank Capacity
(Liters / Pints)
Operating Noise Level
Unit Dimensions Width / Height / Depth
Net Weight (kg / lbs.)
NOTE: Specifications are subject to change without notice, for further improvements.
(Pints / Liters)
(Cubic Feet per Minute)
(dB A)
4
DDR600R
60 / 28.4
115 Volts / 60 Hz
785
7.26
Not Applicable
183 / 160
R22
5.3 / 11.2
50
13-3/4" x 30-1/2" x 13-3/16"
25 / 55.1