Weed Eater LE Serie Manual De Instrucciones página 7

HoId the unit in the starting position as
shown. Make sure the blower end is di-
rected away from people, animals, glass,
and solid objects.
STARTING POSITION
Blower
/
\
Vacuum
Z_
r=WARNING:
When starting engine,
hold the unit as illustrated. Do not set unit on any
surface except a clean, hard area when starting
engine or while engine is running. Debris such
as gravel, sand, dust, grass, etc. could be
picked up by the air intake and thrown out
through the discharge opening, damaging the
unit or property, or causing serious injury to by-
standers or the operator.
HELPFUL TIP
!f your engine still does not
start after foflowing these
instructions, ptease catl
1-800-554-6728.
STARTING A COLD ENGINE
1. Move throttle lever to the '_ position.
2. Move choke lever to the FULL CHOKE
position.
3. Slowly press the primer button 8 times.
Throttle Lever Primer Button
/
4. Pull starter rope sharply until engine at-
tempts to run, but no more than 5 pulls (be-
low 30 _ F, 8 pulls).
NOTE: If engine attempts to start before the
5 th pull, go to next step immediately.
5. Move the choke lever to the HALF
CHOKE position.
6. Pull the starter rope sharply until the en-
gine runs, but no more than 5 pulis (below
30 _ F, 10 pulls).
7. After a 5 second warm-up, move the
choke lever to the RUN position.
8. Allow the unit to run for 30 more seconds
at the RUN position before moving the
throttle tever to the _ position.
If engine has not started after 5 pulls (at HALF
CHOKE), repeat STARTING A COLD ENGINE
procedure. If engine still does not start, proceed
to STARTING A FLOODED ENGINE.
9. To stop the engine, move the throttle lever to
the STOP position.
STARTING A WARM ENGINE
NOTE: If fuel tank is empty, add fuel; then,
follow STARTING A COLD ENGINE proce-
dure. Do not fill fueI tank while engine is hot.
1. Move throttle lever to the '_ position.
2. Pull starter rope sharply until engine runs,
but no more than 5 pulis.
NOTE: If engine has not started, pull starter
rope 5 more pulis. If engine still does not run,
it is probably flooded.
3. To stop the engine, move the throttle lever to
the STOP position.
STARTING A FLOODED ENGINE
Rooded engines can be started by placing the
choke lever in the RUN position. Move throttle
lever to the fast position 4"_ ; then, pull rope
until engine starts. After engine starts, move the
throttle lever to the slow position "4111" t o allow
engine to idle.
Starting could require pulling the starter rope
many times depending on how badly the unit is
flooded.
If unit still doesn't start refer to the TROUBLE-
SHOOTING TABLE or call 1-800-554-6723.
Choke Lever
-7-