Kreg ADAPTIVE CUTTING SYSTEM Manual Del Propietário página 2

Kreg Project Table Extension Brackets are intended for use with the
®
Kreg Adaptive Cutting System Project Table to extend the work surface or
®
provide workpiece support when used in combination with 2x4 lumber and
the Kreg Mobile Project Center or the Kreg
®
Install the brackets
(1) Tip up the Extension
Bracket and insert the
tabs into the T-slot in the
Project Table side rail.
(2) Tip the bracket down
until the supports
touch on the bottom
edge of the table rail.
Repeat with the
second bracket.
INSTALLATION
Support
Track Horse.
®
Side Rail