O
PERATION
Operation
Hearing damage due to high volumes!
• Before putting the receiver on lower the volume setting and gradually
increase the volume to suit.
• Do not continuously expose yourself to high volumes.
1 Switch on the audio source. The green indicator LED on the transmitter
will glow constantly.
2 Switch the On/Off switch on the receiver to ON position,
3 The neck-loop induction cable can transmit the audio signal to the hearing
aid device for listening (Note : any earphone/headset must be pulled out
from the 3.5 mm audio output jack).
4 Adjust the tone clarity setting to achieve optimum performance.
Note: When the battery level is low you will hear 3 beeps every minute
in the receiver. The receiver will be switched off automatically after 5
minutes.
The microphone button
The microphone opening at the side of the receiver pick up the sounds of
your surroundings. When the microphone is switched on, you will hear
your surroundings louder. You can hear for example your door bell, your
telephone or your conversational partner louder when you are wearing the
receiver.
Press the button to switch the microphone on. The power on indicator will
turn from green to red and two short beeps are to be heard. Make sure that
the microphone opening is not covered!
You can hear your surroundings and you use the receiver as an assistive lis-
tening device which helps you hear other people better.
To switch the microphone off press the button again. The power on indica-
tor will turn to green and you will hear the sound from the audio source.
26
Helpline UK 0844 800 6503
(See page 32 for costs and hours of operation)