Amplicomms TV 2510NL Manual De Instrucciones página 31

Tone clarity
You can set the tone clarity with the key on the transmitter. Press and
release the required key repeatedly. The current setting will be indicated by
the status of the three LED's.
The following table shows the settings. Try out which setting works best for
you.
Setting LED indicator (orange)
Default
Stereo / mono switch - transmitter base
Although the output from the neck loop will always be a mono signal, if the
source output is in stereo, the resultant output can be affected as follows:-
If you want both stereo channels from the source signal to be equally blen-
ded into a mono signal, switch to mono (this is the recommended setting).
Left or right channels can be partially filtered by switching to stereo and
adjusting the balance control on the headset.
(See page 32 for costs and hours of operation)
Effect
Flat
Bass Boost +
Treble Boost
Treble Boost
Bass Boost
Helpline UK 0844 800 6503
O
PERATION
27