afx light PROWASH-540RGB Manual De Instrucciones página 2

Please read this manual carefully before operating this product.
The lightning flash with arrowhead symbol, within an equilateral Triangle, is intended to alert
the user to the presence of not insulated dangerous voltages within the product's enclosure
that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the pre-
sence of important operating and maintenance (servicing) instructions in the literature ac-
companying the appliance.
• Please keep this User Manual for future reference. If you sell the unit to another user, be sure that
he also receives this instruction booklet.
• Unpack and check the unit carefully that it has not been damaged during transport before using
the unit.
• Before operating, ensure that the voltage and frequency of power supply match the power requi-
rements of the unit.
• The unit should be connected to a main socket outlet with a protective earth connection
• The unit is for indoor use only
• The unit must be installed in a location with adequate ventilation, at least 0.5m from adjacent
surfaces. Be sure that no ventilation slots are blocked.
• Disconnect mains power before fuse replacement or servicing.
• Replace fuse only with the same type.
• Make sure there are no inflammable materials close to the unit during operation.
• Use safety cable when fixing this unit.
• In the event of serious operating problem, stop using the unit immediately.
• Never try to repair the unit by yourself. Repair carried out by unskilled people can lead to damage
or malfunction. Please contact the nearest authorized technical assistance center and always use
the same type of spare parts.
• Do not touch any wires during operation as high voltage might be causing electric shock.
• The product is for decorative purposes only and not suitable as a household room illumination.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and able to support a weight of 10 times of the unit's weight. Also
always use a safety cable that can hold 12 times the weight of the unit when installing the fixture.
The equipment must be fixed by professionals at a place where is out of the reach of people and
where nobody can pass by or under it.
Up to 5 units can be daisy-chained.
EN 2
USER MANUAL
CAUTION
DO NOT OPEN THE HOUSING
SHOCK HAZARD
in a dry location.
© Copyright LOTRONIC 2019