Napa 6-1134 Manual De Instrucciones página 3

AIR SUPPLY
Tools of this class operate on a
wide range of air pres sures. It is
recommended that air pres sure of
these tools mea sure 90 PSI at the
tool while running free. Higher
pres sure
(over 90 psig; 6.2 bar)
performance beyond the rated
capacity of the tool, which will
short en tool life be cause of faster
wear and could cause injury.
Always use clean, dry air. Dust,
corrosive fumes and/or water in the
air line will cause damage to the
tool. Drain the air tank daily. Clean
LUBRICATION
Lubricate the air motor daily
with quality NAPA air tool oil.
If no air line oiler is used, run
1 oz. of oil through the tool.
The oil can be squirted into the
OPERATION
Locate center of new hole by using
a center punch. Place drill bit tip in
punch mark. Hold drill square with
work and start motor. Apply steady,
even pressure. Do not force. Too
much pressure can cause bit
to break or overheat. Too little
pressure will keep the bit from
cutting and cause it to overheat.
Reduce pressure just before bit cuts
through the work. When bit has
penetrated work and is spinning
please revieW all Warning insTrucTions prior To operaTion. save This Man u al for fuTure ref er ence.
6-1134
the air inlet filter screen on at
least a weekly schedule. The
rec om mend ed hookup pro ce dure
can be viewed in the above figure.
The air inlet used for con nect ing
raises
air supply, has stan dard 1/4" NPT.
Line pressure should be increased
to compensate for unusually
long air hoses (over 25 feet).
Minimum hose diameter should be
3/8" I.D. and fittings should have
the same inside di men sions and be
tightly secured.
tool air inlet or into the hose at
the nearest con n ec t ion to the
air supply, then run the tool.
Overfilling will cause a re d uc t ion
in the power of the tool.
freely, take it from the work while
the motor is running, then turn
off the drill. If the drill jams in the
work, release throttle immediately.
Disconnect the drill before removing
bit and determining cause of trouble.
Do not attempt to free the bit by
starting and stopping the motor.
3
S
pecificationS
Chuck Size ...............................3/8"
Free Speed ................... 1,800 RPM
Air Inlet .......................... 1/4" NPT
Min. Hose Size ................ 3/8" I.D.
Spindle Thread ................ 3/8" -24
Avg. Air Cons. .................... 4 CFM
Sound Level .......................82 dbA
Net Wt. ............................ 2.76 lbs.
Overall Length ......................7.48"
Recom. Air Pressure .....................
............................. 90PSIG (6.2 bar)
Forward/Reverse
Lever
Air Inlet
120111