Others - Pioneer SBX-B30 Manual De Instrucciones

Others

Problem Check
Power does not turned Is the power cord properly
on. connected?
The unit's power turns off
automatically.
The unit cannot be
operated.
Cannot be operated with Are you operating the remote
the remote control. control from a point too far
away from the unit?
Is the battery dead?
Settings I have made have y Have you disconnected the
been cleared. power cord while the unit's
power was on?
y Has there been a power
failure?
I want to adjust the
brightness of the
indicators.
The input selection
indicators are flashing
red.
The unit becomes hot
during use.
Turning up the unit's Is the audio output for the TV
volume using the TV internal speakers set to off?
remote control causes
sound to also come out
of the TV. (Remote control
learning function)
Unable to have the unit Light fixtures or the TV may
learn the TV remote be interfering with the remote
control. control sensor on the unit.
Troubleshooting and Other Information
Remedy
y Plug the power cord securely into the power outlet.
y Unplug the power cord, wait several seconds, then plug the power
cord back in.
If Auto Power Off is set, the unit's power automatically turns off. Check
the Auto Power Off setting (page 11).
Unplug the power cord, wait several seconds, then plug the power cord
back in.
Operate from within 7 m of the remote control sensor.
Replace the battery (page 5).
Wait for at least 10 seconds after the unit display disappears and then
make sure you press the u/I
remote control before disconnecting the power cord. Be particularly
careful when the power cord is connected to the AC outlet on another
device because the unit turns off in conjunction with the device.
Press the DIMMER on the remote and select the desired display
brightness.
Before use, unplug the power cord, wait several seconds, then plug the
power cord back in.
If the problem is not resolved, contact the Pioneer Customer Support
Center.
The temperature of the unit cabinet may increase slightly during use
depending on the operating environment. This is not an indication of a
malfunction so you can continue using the unit without worrying.
Turn the audio output for the TV internal speaker to off. If no such
setting is possible, set the TV volume to the minimum again.
If the volume of the unit is controlled using the remote control learning
function, audio may also be output through the TV speakers, depending
on the make of the TV.
Change the direction of the light fixtures, or turn off the power to the TV,
and then attempt the learning again. If the learning function still does
not work, the remote control is not supported by the unit. Please control
the unit using the supplied remote control.
on the unit or the power button on the
17
En