Use; Preliminary Checks; Preliminary Adjustments - Tecomec Geoline DRIVER Manual De Uso

5 USE

Preliminary checks

Important checks, listed below, must be carried out every time the system is used.
- Check and, if necessary, clean the unit filter on the delivery line (if present). Check the system's other filters.
- Check the condition of the system's hoses and their connections.
- Check the system's electrical cables and their connections.
- Check the battery's charge.
- Verify that all of the delivery hoses to the users are closed. One open user could injure people, animals, or damage
things.
- Before starting the pump, make sure that the unit's main valve is in the OFF position (drain).

Preliminary adjustments

Before starting treatment, make these adjustments to the control unit.
These calibrations will then be repeated every time the nozzle or sprayer is changed (the amount of fluid dispensed
per hectare).
1 Fill the tank with water. Do not use chemical products
during these adjustments.
Place the main control valve in the drain position (OFF)
2
with switch .
A
B
Completely close the volumetric valve with switch
3
pressed toward ). Check the circuit's pressure. If it goes
+
above the maximum limit, verify that the pressure relief
valve is completely open (as shown in point 4).
C
Completely open the pressure relief valve with knob
4
(turn counter-clockwise).
30
P00801017_R05.indd 30
A
(keep
B
C
C
U s e & M a i n t e n a n c e
Place the section valves in the closed position (OFF) with
5
switch .
D
Bring the tractor PTO to the desired rpm and start the
6
pump.
Place the main control valve in the open position (ON)
7
with switch .
A
8 Place the section valves in the open position (ON) with
switch .
D
M a n u a l
5
ENG
D
A
D
04/02/2011 16.28.36