Publicidad
Idiomas disponibles
Idiomas disponibles
DM 2610914511 03-08
Mount Table to Workbench
The SHAPER/ROUTER TABLE comes
assembled ready to mount to the workbench.
After determining table location, predrill the
bench using a 1/8" diameter drill at the four
mounting hole locations. Secure table to the
bench using the (4) #10 x 1" wood screws,
and
washers.
Shaper/Router Table). (See Fig. 1)
Alternative mounting option: To make your
shaper table more portable, mount to piece of
2" x 4". Then easily clamp to your work bench
as shown in Fig. 1.
Install Rotary Tool to Table
1. Loosen the clamp knob and turn depth
adjustment knob to lower tool holder.
2. Loosen the two tool holder knobs. You
may opt to use your Dremel wrench (as
pictured) or a coin (penny or dime) to
tighten/loosen the two tool holder
knobs. Using the screwdriver end of the
wrench will damage the knob. Insert the
tool into both clamps then align the switch
facing front (switch will be facing the
user – giving a left to right motion for
turning motor off). Be sure nose is
seated all the way in small clamp. Secure
tool by tightening the two tool holder
knobs. (See Fig. 2)
ADAPTER FOR USE WITH DREMEL
CORDLESS ROTARY TOOL MODEL 780 ONLY
The Cordless Rotary Tool Model 780 can be
used with all Dremel attachments. This
adapter ring will allow you to use your new
Cordless Rotary Tool with the 212 Drill
Press, 231 Shaper/Router Table, 330 Router
Attachment, or 2217 Tool Holder.
Read and understand these
!
WARNING
instructions and the tool
manual before using this accessory.
To Install the Cordless Rotary Tool
Model 780 into the Attachment:
1. Place the adapter ring that came with
your 780 Cordless Rotary tool in the
large clamp of the attachment, aligning
the split of the adapter ring to the split of
the large clamp. (See Fig. 3)
2. Loosen the two tool holder knobs
several turns. Place the Cordless Rotary
Tool in the clamps making sure the nose
of the tool is seated all the way in the
small clamp. With the speed dial and
collet lock to the side, secure the tool by
tightening the two tool holder knobs.
3/11/08
1:39 PM
(Included
with
the
Page 5
Fig. 1
(4) #10 x 1"
Wood Screws &
Washers
Fig. 2
Clamp
Knob
Depth
Adjustment
Screw
Fig. 3
Adapter Ring
5
Use 2" x 4" as
alternative
mounting option
Guard
Fence
Tool Holder
Knobs
On/off switch must
face forward so
left-to-right
motion will turn
tool off
Small Clamp
Tool Holder Knob
Large Clamp
Tool Holder Knob
Publicidad
