Mounting The Window / Door Contact - HomeMatic Easy connect Instrucciones De Montaje

5.3

Mounting the window / door contact

5.3.1 Selecting a suitable mounting location
• Select a window or door for mounting the window / door con-
tact.
Fix one part of the window / door contact (magnetic contact (I)
•
or electronic unit (K) to the moving part (door or window wing),
the other one at the stationary part (frame) of the window or door
(see figure 6).
• Fasten the window / door contact on the side of the window or
door where the handle is located, in the upper third of the win-
dow/door frame (see figure 6) (for fastening see „5.3.2 Adhesive
strip mounting" on page 45).
• The magnet contact can be mounted in a horizontal or verti-
cal way, left or right to the electronic unit of the window / door
contact.
The electronic unit and the magnet contact should be
mounted at the same height. You can use a spacer (J) for
the magnet contact.
The ideal spacing between the housing edge of the window
/ door contact and the magnet contact should be 5 mm
(see figure 6).
5.3.2 Adhesive strip mounting
When using adhesive strips, make sure that the mounting
surface is smooth, non-disturbed, free of dust, grease and
solvents and not too cold.
Installation
45