Water Connection; Instruction For Use - Lotus BR 50-78 ET Instrucciones Para La Instalación

Water connection

Water connection is performed with hose threaded G1/2. The water supply must be equipped with a
separate valve which is freely available and within range of the device. The equipment includes a check
valve.
• Water hardness must be in range 0,5 - 5 ° French degree. If higher, it is necessary use water softening
system.
• Water pressure must be within range 50 - 250kPa.
• Volume of chlorine in the water shall not be higher than 10ppm, or you risk bath surface damage
• Acidity of water must be higher than 7 pH.
• Electrical conductivity: 50 - 2000uS/cm (20°C)
• The connection must be made according to directive EN 1717 and with valid to national directives for
aquaculture.

Instruction for use

Attention! Before the first use of the appliance you must remove protection foil, wash the device and bath
with water containing washing liquid and then dry with the cleaning cloth. Into the bottom of the bath spread
a vegetable oil and begin burning procedure by 230°of Celsius. Before you start cooking, it is necessary
make this burning procedure. The optimum is about 3–5 days use appliance as frying pan, and then for
cooking. If pans washing was done by chemical substances, we recommend to use about 4-6 cycles as
frying pan before you start cooking in it again. The device cannot be used under any circumstances as a
fryer or its substitute
Attention!
Never leave device unattended while in use. Always use device under supervision. Tilting pan can be used
for meat frying, sauce cooking, potato cooking, soup making etc. Never switch device on, if is pan empty.
Switching on and off
Turn the control knob to right and set required temperature between 45 - 295 ° degrees of Celsius. When
device switched on, orange control light is lighting, green control light is indicating working heaters. If green
light goes off, temperature is set. To switch the device off, set control knob back to position 0.
Filling water to the bath
Open valve for water filling and when achieve required volume of the water, simply close it. Water fills up
only when the lid of the bath is open.
Draining of the bath
Tilt the bath to required position for her drain with help of the manipulation handle. Attention! Before you
start draining of the bath, attach under overflow suitable container. Keep maximum attention if you will be
manipulating with boiling content. After successful bath draining, return it back to operation position
9