Service Parameters; Using The Service Parameters - Adam Equipment ABK Serie Manual De Usuario

EN
12.0

SERVICE PARAMETERS

The scales will allow entry to the parameters if the [Tare] key is pressed
during the power on cycle. The passcodes work as explained earlier.
In this case the display will show the passcode request screen, " P - - - - " . To
continue enter a passcode as described below.
Entering passcode 0000 will allow calibration as shown in section 11.
Entering 1000 will allow access to a limited set of parameters described in
section 12.1.

12.1 USING THE SERVICE PARAMETERS

Press the [Z/T] key during the display countdown when turning on,
When "Pn" is displayed, enter the number 1000 using the [Unit/] and
[Pcs/ ] keys and then press [Z/T].
The display will show the first parameter called "F4 Int".
To select another parameter press the [Pcs/ ] key which will advance
through the parameters available. Full details are in the full version of the
user manual.
© Adam Equipment Company 2015 16 3116611621RevA1-Feb15