Technical Data - Beta 3027/PR Manual De Uso E Instrucciones

ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS
PROCEDURE
- Place the spacer units onto the supporting plate and adjust the units' position (fig. 3/a).
- Tighten the threaded screws in the columns (fig. 3/b), adjusting the screws' height to find three stable supporting
points on which to place the hub from which to remove/into which to insert the bearing.
- At this point, lock the position of the spacer units (fig. 4).
Make sure that the support in the aforesaid three points is adequate; the hub should be in the correct
position (fig. 5). The hub's axis must strictly match the force's direction.
After positioning the hub, you must tighten the 3 M16 nuts to the threaded screws.
Make sure the assembled tool is in the correct position on the press. The supporting plate's safety screws must be on
the outside of the press' cross members or supporting bars (fig. 6).
The foregoing steps ensure the necessary safety to prevent slipping or accidental dropping of the plate.
Always work with due precaution.
Then activate the press and remove (fig. 7).

TECHNICAL DATA

SIZE
WEIGHT
MAX. LOAD-BEARING CAPACITY
WORKING RANGE
300x300 mm
13 kg
20 t
min. 130 mm - max. 186 mm
EN I
7