Publicidad
Instructions for ARGB controller
1.
There are three buttons on this controller, "+ / – / M"
2.
M button: Press M button to switch to lighting effect mode, speed of lighting mode, brightness mode, and demo
mode. Press "+" or "–" to adjust desired levels.
3.
Press M button for 3 seconds to turn off, press M button again to turn on and resume to the last lighting effect
before turning off.
4.
When powered on for the first time, default lighting effect is "Rainbow"
5.
After turning off or sudden power loss, the controller will resume to the last set lighting effect and level after
power on.
6.
Press "–" button for 3 seconds under any modes will reset to default effect (Rainbow)
7.
Lighting effect mode
1)
Rainbow (default)
2)
Breathing
3)
Flashing
4)
Layering (8 colors: white, indigo, violet, yellow, blue, red, green, orange)
5)
Flowing
6)
256 colors auto switching (8 colors: white, indigo, violet, yellow, blue, red, green, orange) Press "+" for 3 seconds
to lock the chosen color; press "–" for 3 seconds to unlock color.
7)
Radar
8)
Color layering, red
9)
Color layering, green
10)
Color layering, blue
8.
Press M button to switch mode.
Press "+" or "–" when controller's red indicator lights up to adjust speed of lighting (fast / slow)
9.
Press M button to switch mode.
Press "+" or "–" when controller's blue indicator lights up to adjust brightness
10.
Press M button to switch mode.
Under demo mode, controller's yellow indicator lights up and will display and recycle all 10 lighting effects
continuously.
14
Publicidad
