Cleaning Process - Silvercrest SUR 46 B1 Instrucciones De Servicio

__GRA76041_B5.book Seite 37 Montag, 27. August 2012 5:46 17
• Figures C+D: Place one CD/DVD on
the spindle|12. Use the spacer ring if
you wish to clean 2 CDs/DVDs simulta-
neously.
Toiletries / writing utensils
You can use the ultrasonic cleaner to clean
dentures/braces, shaving heads of electric
razors, razor blades and similar toiletries.
The device is also suited for cleaning e.g.
tips of fountain pens, sleeves of ballpoint
pens and printer nozzles.

5.4 Cleaning process

DANGER of electric shock!
• Only connect the device to an easily
accessible wall socket whose voltage
corresponds to the specifications on the
rating label. The wall socket must con-
tinue to be easily accessible after the
device is plugged in.
• Pull the mains plug|5 out from the wall
socket after every use.
DANGER by ultrasonic
waves!
Do not touch the inside of the stain-
less steel tank or the cleaning fluid
during the cleaning process: ultra-
sonic waves may cause injury to
health.
WARNING! Risk of material
damage!
• Never use the device without water,
since this may damage it.
• Once you have used the device five
times in a row, stop the cleaning process
and leave it to cool to room temperature.
• An extended cleaning period and repeat-
ed cleaning may cause loosely fastened
fittings, labels or decoration at objects as
well as other parts, which are not fixed
such as screws of eyeglass frames, to
come off during the cleaning process.
• Adding dishwashing detergent may
cause the removal/dissolution of labels
and adhesives.
1. Open the lid|4.
2. Fill the stainless steel tank|2 with clean-
ing fluid. The cleaning fluid must cover
the parts to be cleaned. However, the
maximum filling level MAX|1 must not
even be exceeded with the objects in
place. A suitable cleaning fluid is usually
cold, clean tap water. The cleaning ef-
fect can be intensified by adding dish-
washing detergent (please observe
manufacturer's information). Do not use
corrosive cleaning agents, ammonia,
bleach or strongly perfumed cleaning
agents.
3. Place the objects to be cleaned in the ul-
trasonic cleaner. Use the insets.
4. Close lid|4.
5. The device is switched on when the
mains plug is connected. Connect the
mains plug|5 with a wall socket. The
display|6 shows 180.
6. Press the button SET|8 repeatedly until
the requested cleaning period appears
on the display (180, 300, 480, 600,
090 seconds) - depending on the de-
gree of staining.
090 seconds: recommended for minor
staining and objects such as eyeglasses
180 seconds: standard time for normal
staining
300 seconds: recommended for the ini-
tial cleaning with the ultrasonic cleaner
480 seconds: recommended for the ini-
tial cleaning if several objects are
cleaned simultaneously
600 seconds: recommended for severe
staining.
7. Press the button START|9 to start the
cleaning process. The power LED|3 is lit
blue and the seconds are counted down
on the display. During the cleaning proc-
ess, a buzzing / humming can be heard.
37
GB