Putting Into Service; How To Operate - HAEGER Hover Plus Instrucciones De Uso

Putting into Service

Position
The ideal position is a non-slip, flat surface.
Do not place the device immediately next to stoves or other sources of heat.
Electrical Connection
1. Connect the device to a duly installed 220-240V~50Hz protective contact
socket.
2. Before inserting the plug into the socket. Make sure that the mains voltage
to be used matches that of the device. You can find this information on the
nameplate.

How to operate

1. Make sure that the fan is on a firm, level surface.
2. Install feet before operating the fan. Insert the front part of
the feet first and then push back until it snaps into place.
3. Making sure the speed control is at OFF position.
4. Plug the power cord into the socket.
5. Turn the speed control and set to the correct position
depending on the air flow desired:
0 – OFF, 1 – Low, 2 – Medium,
6. To tilt the head of fan simply move the fan body up or down gently until the
fan is positioned in the desired position.
7. Set the speed control to position 0 to switch off the fan.
Cleaning
1. Be sure your fan is in the OFF position.
2. Unplug the fan before cleaning.
3. To clean inlet and outlet ribs, use a common household vacuum.
4. Do not use water to clean these parts of the Fan.
5. Do not disassemble for cleaning.
6. Do not immerse the fan in water and never allow water to enter
the Motor Housing.
7. Do not use gasoline, paint thinner or other chemicals to clean the
fan.
Instructions for use
3 – High
English
3