Installing/Removing The Battery Pack - Ubermann UCS04BRA Manual Del Operador

OPERATION
WARNING:
Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict serious injury.
Applications
You may use this tool for the following purposes:
• Cutting all types of wood products (lumber, plywood, paneling)
• Cross cutting/rip cutting wood products
• Bevel cutting wood products
• Pocket cutting wood products
WARNING:
Never use abrasive cut-off wheels of any kind with this saw. Use
of non wood cutting blades can result in property damage or
serious personal injury.

Installing/Removing the Battery Pack

See Figure 4, page 20.
• Place the battery pack in the saw. Align the raised rib on the
battery pack with the groove inside the saw, then slide the
battery pack into the saw.
• Make sure the latches on each side of the battery pack snap
into place and the battery pack is secured in the saw before
beginning operation.
• Depress the latches to remove the battery pack.
For complete charging instructions, see the operator' s manuals
for your battery pack and charger.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked when not in use or carrying at
your side.
Blade Guard System
See Figure 5, page 20.
The lower blade guard attached to your circular saw is there for
your protection and safety. Do not alter it for any reason. If it
becomes damaged, do not operate the saw until you have the
guard repaired or replaced. Always leave guard in operating
position when using the saw.
DANGER:
When sawing through work, lower blade guard does not cover
blade on the underside of work. Since blade is exposed on
underside of work, keep hands and fingers away from cutting
area. Any part of your body coming in contact with moving blade
will result in serious injury.
WARNING:
To avoid possible serious injury, never use saw when guard is
not operating correctly. Check the guard for correct operation
before each use. The guard is operating correctly when it moves
freely, and instantly returns to the closed position. If you drop
the saw, check the lower blade guard and bumper for damage at
all depth settings before reuse.
WARNING:
Never tie the lower blade guard in a raised position. Leaving the
blade exposed could lead to serious injury.
If at any time the lower blade guard does not snap closed,
remove the battery from the saw. Exercise the lower guard by
moving it rapidly back and forth from the full open position to
the closed position several times. Normally this will restore the
guard to its normal operating condition. If it does not correct a
slow or sluggish closing lower guard, do not use the saw. Take it
to an authorized factory service center for repair.
11 — English