Assembly - Rubi DT180EVO Manual Del Operador

ASSEMBLY

UNPACKING
See Figure 5.
This product requires assembly.
 Carefully lift the saw from the carton and place on a level
work surface.
WARNING:
Do not use this product if any parts on the Loose
Parts List are already assembled to your product
when you unpack it. Parts on this list are not as-
sembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
NOTE: Many of the Loose Parts are stored in the water
reservoir.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-866-872-RUBI (7824) for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this tool until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in acci-
dental starting and possible serious personal injury.
TILE CUTTING WHEEL
For maximum performance and safety, it is recommended
that you use the 7 in. cutting wheel provided with your
saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no
load speed of this tool. Failure to heed this warning
could result in personal injury. Do not use wheel
with cracks, gaps, or teeth.
INSTALLING MOTOR HEAD ASSEMBLY TO
FRAME
See Figures 6 - 8.
 Place spacers in the top holes of the frame as shown in
figure 6.
 Align the holes in the motor head assembly with the holes
on the water tray frame.
 From under the water tray frame, insert three socket head
screws up through the frame, spacers, and motor head
assembly.
 Secure screws in place using hex nuts. Finger tighten
then lightly torque using wrenches.
 Place spacers in the side holes of the frame as shown in
figure 7.
 Insert socket head screws through the motor head
assembly, spacers, and into the side of the frame. Finger
tighten then lightly torque using wrenches.
 Once all screws are lightly torqued, return to the first three
screws and tighten. Tighten the two screws on the side
of the frame last.
 Place the frame on the water tray as shown in figure 8.
MOTOR HEAD
ASSEMBLY
SOCKET HEAD
12 — English
HEX NUT
SPACER
SCREW
Fig. 6