Livington PRIME Steam Mop Instrucciones De Uso página 20

2. Hold the appliance in place and make sure that the steam cleaner is not directed at floors, surrounding objects or surfaces. Plug the
applaince in, switch it ON, by pressing the power button (6) and leave it to produce steam, until the vinegar-water solution is used up.
3. Repeat the above process as often as necessary until the steam emission has reached a normal level.
4. Fill the water container with fresh water and rinse it out.
5. Fill the water container with fresh water, reinstall it in the appliance and let the steam escape until the container is empty
WARNING: RISK OF SCALDING
Never leave the steam cleaner unsupervised during the process of removing calcium deposits or during normal use.
Please Note: Test the appliance prior to use on a suitable spot to make sure that there are no more deposits.
6. Cleaning blocked accessory parts: Due to the high rate of minerals in the water of some areas, less steam may be emitted from
the hand steam cleaner. This could be due to calcium deposits in the nozzle tip.
7. For the elimination of calcium deposits, please proceed as follows: We recommend the use of a sprayable lubricant. Spray once
or twice, in short bursts, into the tip of the nozzle. Then fill the steam cleaner with water, in accordance with the instructions, and
leave it for a few minutes to continuously emit steam through the nozzle concerned, to remove the deposit.
8. As soon as the part concerned is clean again and the steam can escape unhindered, direct the steam cleaner onto a neutral
surface or a cleaning cloth to make sure that no more small particles are escaping with the steam.
Cleaning of the microfibre cloths: Composition: 74% polyester, 17% Polyamide, 9% Acyrl
Trouble-shooting
Warning: Make sure the appliance is unplugged before carrying out any service jobs.
Problem
APPLIANCE WILL NOT START
LESS OR NO STEAM EMISSION
STEAM EMISSION AT THE
CONNECTION JOINTS
CLEANING CLOTH IS WET AND
SLIDES THROUGH
WARRANTY PROVISION
All defects arising from incorrect use, for example, overheating, discolouration, scratches, damage due to falling on the floor, repair
attempts and incorrect cleaning, are excluded from the warranty. Also excluded are purely visual traces of use. This also applies to
normal wear and tear.
20
M16625_M17378_Livington PrimeSteamMop_Manual_A5_20181023_BA.indd 20
Possible cause
The appliance is unplugged or the power
button is not set to the ON position (6)
Water container is empty
Jet nozzle is blocked
Calcium deposits
Hose in the water tank is kinked
Attachment is not fully connected
Deposits or blockages at the connection
joints
The cloth is saturated with water
Solution
Make sure that the appliance is
connected to a reliable source of
electricity and the power botton is set
to ON (6).
Fill up the water container
Remove the mop-head and clean the
nozzle
Follow the cleaning instructions in
this user handbook to remove calcium
deposits
Eliminate the kink from the hose in the
water tank
Switch the appliance OFF, leave it to
cool down, remove the attachment and
reinstall it correctly.
Remove the attachment, check and
clean the connection joints.
Remove the wet cloth and replace it with
a new one. Alternatively, leave the cloth
to cool down, wring it out thoroughly
and reattach it.
23.10.18 12:18