Cleaning, Maintenance And Ordering Of Spare Parts; Maintenance And Storage; Disposal And Recycling; Ordering Replacement Parts - EINHELL GC-RS 60 CB Manual De Instrucciones

8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.

8.1 Maintenance and storage

•
Clean the machine regularly. This will help to
keep the machine in good working order and
is the basis for a long working life.
•
Keep the vent slots clean while you work.
•
Clean the plastic body and other plastic parts
with a mild household cleaning agent and
a damp cloth. Do not use any aggressive
agents or solvents for cleaning purposes.
•
Never clean the shredder by spraying with
water.
•
Prevent water getting inside the machine at
all cost.
•
Check the chassis securing screws from time
to time to ensure that they are tight.
•
If you do not intend to use the shredder for a
lengthy period, protect it from corrosion using
environmentally friendly oil.
•
Store the device in a dry room.
•
Store the device out of reach of children.
The equipment must be cleaned and conser-
ved at the end of the season.
Important: Wear work gloves!
Undo the 4 Allen screws (Fig. 15a/Item K) fully.
The Allen screws can only be undone – they can-
not be removed. Undo the retaining screw on the
bottom side of the equipment (Fig. 15b/Item L) as
far as the stop. The retaining screw can only be
undone – it cannot be removed. Now you can take
off the cover (Fig. 15a/Item M). Clean the cutting
compartment, the counter blade and the cutting
unit and cover them with a thin coat of vegetable
oil before installing everything again. At the begin-
ning of the new season the counter blade must be
correctly adjusted as described under 6.8.

8.2 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Anl_GC_RS_60_CB_SPK9.indb 21 Anl_GC_RS_60_CB_SPK9.indb 21
GB

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 21 -
31.10.2019 11:22:00 31.10.2019 11:22:00