Turning On/ Off Description (Ws 05 Only); Dab Function (Dab 05 Only); Fm Function (Dab 05 Only) - THOMSON DAB05 Instrucciones De Funcionamiento

Turning on/ off Description (WS 05 only)

Unzip the antenna and fully extend it. Long press power button to turn on the unit, "BT" image will be
displayed in LCD screen and enter standby mode. Long press the "MODE" button to choose the time
setting, short press the "UP" and "DOWN" button to set the time. Long press the "MODE" button to
confirm time setting and LCD display will show as below:

DAB Function (DAB 05 only)

Press DAB/FM button to switch to DAB mode. DAB information/ DAB signal bar/ current time zone will
be displayed on the screen.
Automatic scanning function on radio channels:
When switching to DAB mode, the whole radio channels automatic scanning task will be started
once. Message of "Scanning... 0" will be displayed. Then, whole part of DAB III channels (174.928-
239.200MHZ) 5A – 13F will be scanned once, showing the total numbers of radio channels afterwards.
The radio channels scanned will be saved automatically by the system. The first radio channel in the
searching list will be played.
Radio manual Tune function:
Under DAB mode, short press the Menu/Enter button to enter the Menu screen, spin the tune button
to "Manual Tune", press Menu/Enter button to confirm the action, DAB frequency will be displayed,
spin the tune button to choose any single frequency from 5A to 13F range. Press the Menu/Enter
button to confirm action. DAB signal bar will be detected and shown by the bottom of LCD screen.
When pressing the Menu/Enter button, the radio scanned will be saved to playlist automatically. Press
the Menu/Enter button again to stop the manual radio searching mode. Radio channels saved in the
playlist will be played afterwards. Please repeat the above steps if searching other radio channels is
needed.
The message of "Service not available" will be displayed by the screen if there is no available radio
signal.

FM Function (DAB 05 only)

Press the DAB/FM button to switch to FM mode, the screen will display the following information:
FM Auto Tuning function:
• FM mode: Long press the Menu/Enter button, lowest radio channels will be scanned first, up to
highest ones (50KHz Step). Automatic scanning will be terminated and until FM signal is detected.
FM signal will be remained and played in that channel.
- EN 5 -