Valeo Park Vision Manual De Instrucciones página 58

EN
Troubleshooting
1- Once reverse gear is selected,
a sound signal is triggered
when there is no obstacle
behind the vehicle:
1. Check that requested height of
sensors fitted on the bumper from
the floor is respected (between
45 and 60 cm).
2. Check that requested angle of
sensors fitted on the bumper
is respected. If necessary, use
the angle correction rings for
the installation.
3. Check that requested distance
between sensors on the bumper
is respected (< or = 45 cm).
2- Once reverse gear is selected,
an obstacle behind the vehicle
is not detected by the system:
1. Check that requested height of
sensors fitted on the bumper from
the floor is respected (between
45 and 60 cm).
2. Check that requested angle of
sensors fitted on the bumper
is respected. If necessary,
use the angle correction rings
for the installation.
3. Check that requested distance
between sensors on the bumper
is respected (< or = 45 cm).
4. Check the display is not on
mute mode (go to page 46).
58
3- The system indicates a defective
sensor (the display beeps
3 times):
1. Check whether the sensor surface
is clean.
2. Check whether the sensor wires
are plugged in the ECU properly.
3. Check whether the sensor wires
are damaged or not.
4. Check that the sensor is not damaged.
5. Check that the sensor cables are
connected to the control unit (ECU)
in the correct order (markers ABCD).
4- Volume of the audible alert
is too low:
Select the maximum level and check
if it is at the desired level.
5- If the problem persists, please
follow these steps:
1. Check the wiring connection.
2. Check the ECU setting (jumper
selection).
3. Contact the dealer where
you purchased the product.
If 2 consecutives sensors
are in default, the full system
will be set off.
6- There is no image on the display:
1. Is the power supply wire
connected correctly?
2. Is the ignition turned to ACC ON?
3. Is the reverse gear selected?
4. Are the wire connections correct?
5. Check the correct function setting
of the display.
7- Image on the display without
selecting the reverse gear:
Check whether the power wire
of camera is connected to the
reverse light wire.
8- Blurred image or poor quality
image on the display:
1. Check whether there is dirt or
water on the lens of the camera.
2. Clean the lens with a lint with
alcohol, and then dry it with
a clean cloth.
3. The brightness, contrast and
colour intensity can be adjusted.
9- The parking assistance lines
are not parallel to the ground
or the parking space:
1. Check that the camera is between
45 and 60 cm above the ground.
2. Check that the camera is at the
right angle for an obstacle 2.5 m
away, displaying the obstacle
in the center of the screen.
If necessary, correct the angle
with the bracket provided.
10- The parking assistance lines do
not display a correct distance:
Check the angle of the camera,
according to the calibration test
(pages 48).