Supplied Accessories - Onkyo SKR-3600 Manual De Instrucciones

Thank you for your purchase of the Onkyo speaker
system.
Please read this manual thoroughly before using it.
Following the instructions in this manual will
enable you to obtain optimum performance and lis-
tening enjoyment from your new speaker system.
Please retain this manual for future reference.

Supplied accessories

SKR-3600 (surround back speaker)
×
Speaker cord 1 (brown: 9 m)
×
Bracket 1
×
Screw 1
×
Cork spacer 4
Placement
SKR-3600 (Surround back speaker)
When using as a surround back speaker.
It is very important to place your speaker properly to
obtain the optimum sound space for your listening plea-
sure.
The surround back speaker is required for enjoying
Dolby Digital EX or DTS-ES audio. The surround back
speaker will also improve the quality of sound effects
for far more realistic acoustics.
Place the speaker so that its height is 1 meter higher
than that of the listener's ears.
The speaker cabinet is made of wood and sensitive to
extreme temperatures and humidity. Avoid placing the
speaker system in locations subjected to direct sunlight
or in humid places such as near an air conditioner, bath-
room, or kitchen.
Speaker care
Your Onkyo speaker is finished with a very high quality
polymer laminate covering that serves to protect the
wood speaker cabinet.
The covering may be cleaned with a soft cloth moist-
ened with water and a mild soap. Avoid the use of furni-
ture polishes or harsh cleansers.
Use a soft brush or hand vacuum cleaner to remove dust
and lint from the grille material.
1
En-
Using the included cork spacers and
installation bracket
We recommend that you use the included cork spacers
so you can enjoy superior sound. The cork spacers also
prevent the speaker from slipping.
×
1
Mounting on a wall
Wall-mount the speaker upside down. Layer two spac-
ers and attach them to two locations. The plaques rotate
so that you can position the speaker upside down.
Attaching the bracket:
Use the included screw to attach the bracket to the back
of the speaker.
Caution:
• Make sure that the walls are rigid enough for support-
ing the speaker's weight.
• The weight a mounting screw can support varies
greatly depending on the wall material and the posi-
tion of the reinforcing ribs embedded in the wall. Use
the thickest and longest possible mounting screw
whose head diameter is less than 10 mm and shank
diameter is less than 4 mm (consult with your
installer).
Installation using commercially-
available stands and fixtures
The surround back speaker bottom and rear are
equipped with screw holes so that you can attach com-
mercially-available stands or mounting fixtures for a
variety of mounting options. (Two M5 screw holes, 60
mm pitch on the bottom and one M5 screw hole on the
rear.)
Note:
• When attaching
an accessory
item to a speaker,
be careful of the
length of the
screw used. Use
only screw that provide the required strength with a
screw length between 7 and 12 mm.
Cork spacer
Bottom
Bracket
Screw
Cork spacer
5 mm
M5 screw
7 ~ 12 mm