Textron Greenlee UT10 Ultra Tugger Manual De Instrucciones página 5

Tiracables y conjuntos de tracción de cables
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIFIC SAFETY RULES AND SYMBOLS
Inspect and verify the maximum
load-bearing capacity or maximum
strength of all structural supports,
pulling system components and
anchoring systems before setting
up the puller. Any component that
cannot withstand the maximum
cable pulling forces could break
and strike nearby personnel with
sufficient force to cause severe injury
or death.
Do not allow anything other than the
pulling rope to contact the capstan.
A grip, swivel, or other component
could break and strike nearby per-
sonnel with great force.
Failure to observe this warning could
result in severe injury or death.
Do not stand directly under a vertical
pull. Cable could fall suddenly from
the conduit.
Failure to observe this warning could
result in severe injury or death.
Greenlee / A Textron Company
®
Ultra Tugger
10 Cable Puller and Pulling Packages
5
Locate the puller so that it is close to the conduit.
Rope, cable, or connectors can break under tension,
causing the rope to whip violently.
Failure to observe this warning could result in severe
injury or death.
An under-rated or worn rope may break and whip
violently. Use a double-braided composite rope with
the following minimum characteristics:
Average Breaking Strength:
at least 143 kN (32,000 lb)
Failure to observe this warning could result in severe
injury or death.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070

Publicidad

Tabla de contenido
loading

Tabla de contenido