Dometic GROUP WAECO CoolPower MPS50 Instrucciones De Montaje página 14

General safety instructions
2.2 Safety when installing the device
CAUTION!
!
 Ensure that the device is standing firmly!
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
NOTICE!
A
 Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
 For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion
damage might occur. Have the inverter installed by a specialist
(marine) electrician.
Electrical cables
CAUTION!
!
 Lay the cables so that they cannot be tripped over or damaged.
NOTICE!
A
 If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Do not pull on the cables.
 Do not lay the 110 – 240 V~ mains cable and the 12/24 Vg
cable together in the same duct (ductwork).
 Fasten the cables securely.
14
CoolPower MPS50
EN