Technical Data Battery / Charger; Function Of The Unit; Changing The Battery (A); Emergency Stop Button (B-1) - NOVIPRO COMPACT Instrucciones De Uso

2.1

Technical data battery / charger

Battery, art.-no.:
Typ/ model ...................................... Lithium-Ion
Voltage ........................................... 14,4 V DC
Capacity ......................................... 2,6 Ah
Max. discharging temperature. ........ -20°C +60°C
Approx. charging time (90% full) ..... ca. 70 min
Weight ............................................ ca. 470 g
Recharge battery pack before first use!
Deep discharge protection may influence empty
battery detection of the machine!
3

Function of the Unit

3.1 Changing the battery
Insert battery until the catch clicks into place. (LED flashes briefly = Contact made). To remove
press the catch and take out the battery.
If the battery voltage is lower than necessary, the LED flashes red. Charge the battery in
the charger.
3.2 EMERGENCY STOP Button
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
3.3 LED
The LED can indicate the following:
Flashes red: Battery is flat. The current press process will be ended automatically. The ON but-
ton will then be disabled and a new cycle can only be started once the battery has been
charged.
Lights up red: After 10.000 press cycles the LED lights up red after each moulding cycle to in-
dicate that the next inspection is due. An internal counter keeps a record of the number of press-
ing since leaving the factory.
3.4 To switch on
Press the ON button until the pressing process has been completed. The motor cut out indicates
the end of the moulding cycle.
3.5 To insert the press jaw
Remove battery!
 Open the bolt (1).
 Insert the appropriate press jaw for the job in hand (2).
 Lock the bolt (3).
After changing the press jaw it is essential to ensure that, once engaged, the crimping jaw
matches the profile being moulded and the nominal width of the fitting being moulded. A visual
18
176 98 97 Charger, art. no.:
Typ/ model ........................................
Battery
Input voltage .....................................
Input capacity ....................................
Input frequency .................................
Input power .......................................
Charging voltage ...............................
Max. charge current ..........................
Rated output .....................................
Number of battery cells .....................
Weight ..............................................
Pay attention to the electrical outlet
voltage! Check the label on the bottom
of the charger.
ENGLISH
EU 176 98 95
Charger for 14,4V
Li-Ion Akku
220-240 V AC
110V AC
0,4 - 0,8 A max.
50 – 60 Hz
70 W max.
7,2 - 16 V DC
3 A max.
48 W max.
8
ca. 450 g
(A)
(B-1)
(B-2)
(B-3)
(C)