Battery Indicator - König SAS‑SA200 Manual De Uso

Battery indicator

The battery indicator flashes every 45 seconds to show that the smoke alarm is
working properly. When the battery indicator flashes and gives a short beeping
sound, it indicates that the battery has a low capacity and should be replaced
immediately.
3. LEARN button
Follow the next steps to set the MAIN smoke alarm and ASSISTANT smoke
alarm(s) to create a smoke alarm system with 2 or more SAS‑SA200/2002's.
1. Press the LEARN button two times. The LEARN indicator turns from red to
green. This smoke alarm will be the MAIN smoke alarm. Ensure the LEARN
indicator is green before proceeding.
2. Press the LEARN button of the ASSISTANT smoke alarm(s) once. The ALARM
indicator(s) turns on red. Ensure the ALARM indicator(s) are red before
proceeding.
3. Press the TEST button of the MAIN smoke alarm for several seconds in order
to send out the learn signal to the ASSISTANT smoke alarm(s). The ALARM
indicator flashes and the smoke alarm sounds. The ASSISTANT smoke
alarm(s) receive the signal and sounds.
4. Press the TEST button on each ASSISTANT smoke alarm(s) for several
seconds in order to send out the learn signal to the MAIN smoke alarm. The
MAIN smoke alarm receives the signal and sounds.
Note: the number of smoke alarms is unlimited. The maximum range between
2 smoke alarms to communicate with each other is 40 metres.
4. LEARN indicator
5. Mounting plate and holes
Use the supplied screws and plugs to mount the mounting plate to the ceiling.
6. Remove the mounting place
Turn the mounting plate of the smoke
alarm counter clockwise to get access to
the battery compartment of the smoke
alarm.
4
ENGLISH