Ingersoll Rand 2906P Serie Instrucciones página 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
SETTING THE POWER REGULATOR
Impact wrenches are not torque control devices. Fasteners
with specific torque requirements must be checked with
suitable torque measuring devices after installation with
an impact wrench.
Series 2906P Impactools incorporate a power regulator into
the reverse mechanism that allows the operator to have either
full power output in one direction and reduced power output in
the other direction or full power output in both directions. To
adjust the power, proceed as follows:
For full power in both directions, rotate the reverse valve
until the notch on each end of the reverse valve aligns with the
number 5 on each side of the housing.
The numbers 0 thru 5 on the
housing are only for reference
and DO NOT denote a specific
power output. Zero (0)
designates the lowest power
output while five (5) denotes the
highest.
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by
the hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pressure.
ADJUSTMENTS
(Dwg. TPD1247)
WARNING
WARNING
WARNING
For reduced power in the forward direction and full power
in the reverse direction, push the reverse valve inward on the
right side of the tool and rotate the reverse valve until the
notch on the right side aligns with the desired number on the
right side. This provides reduced power in forward but full
power in reverse when the reverse valve is pushed in the
opposite direction. See Dwg. TPD1248.
For reduced power in the reverse direction and full power
in the forward direction, push the reverse valve inward on
the left side of the tool and rotate the reverse valve until the
notch on the left side aligns with the desired number on the
left side. This provides full power in forward but reduced
power in reverse when the reverse valve is pushed the
opposite direction. See Dwg. TPD1249.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
(Dwg. TPD1248)
(Dwg. TPD1249)