5.3 Remote control via FS-2PARL
Via the foot-operated remote control FS-2PARL
available as an accessory, up to 50 spotlights can
be controlled together.
1) Connect the jack RJ45 (16) on the rear side of
the remote control FS-2PARL via the supplied
cable to the jack (4).
2) Adjust the spotlight to the DMX address 001
(
chapter 5.4.2).
3) No DMX signal must be present at the input
DMX IN (5).
4) Via the output DMX OUT (6) further PARL-
32DMX units may be connected (
5.2) to control them together with the main unit
via the remote control. For the identical control
of the slave units in principle, adjust their DMX
address to 001 as well. For partly opposite con-
trol and running light effects for the music-con-
trolled programmes
5.3.2) set the slave units to the DMX addresses
005, 009, 013, 001, 005, 009, 013, etc.
5.3.1 Switching the light on and off
The light is switched off and on again with the but-
ton BLACKOUT (15) on the remote control. With
the light switched off (Blackout) the display (12) of
the remote control is dark.
It is possible to select another colour or another
light programme with the light switched off (
following chapters). Then the selection is shown on
the display (12) but will only be active when the but-
ton BLACKOUT is pressed again.
5.3.2 Programmes
The following programmes may be selected with
the button MODE (14):
The lighting colour changes automatically
with slow fadings.
The lighting colour is changed by music
control.
The lighting colour is changed by music
control, partly with running light effects for
several spotlights.
Music-controlled stroboscope in white
Music-controlled stroboscope with chang-
ing colours, partly opposite for several
spotlights.
For music control the remote control has a micro-
phone (17) of its own. Adjust the control SENSI-
TIVITY (18) for the microphone sensitivity so that
the dynamic power of the music is reproduced by
the spotlight in an optimum way. For programmes
chapter
and
(
chapter
the
and
, the colours are automatically
changed during music breaks after a few seconds.
The programme last selected is automatically saved.
5.3.3 Colour spotlight with selectable colour
The following colours can directly be selected with
the button COLOUR (13):
white
red
green
blue
purple
cyan
yellow
pink
orange
light green
The colour last selected is automatically saved.
GB
13