TEC B-450-HS SERIE Manual De Instrucciones página 18

8. LOADING THE PAPER
4. Put the paper roll and supply holders on the supply holder unit.
NOTE: The paper must be loaded so that the print side faces upward.
5. Push both sides of the supply holder guides against the paper roll, then lock them with the lock lever.
NOTE: Make sure that the supply holders rotate slightly.
Paper Guide Lock Lever
Supply Holder Guide
6. Lift up the paper guide lock lever to release the paper guides.
7. Draw the label towards the paper guides.
8. Release the lock lever in the direction indicated by the arrow, and gently lift the sensor cover.
NOTE: Lift the sensor cover gently so that it does not touch the ribbon.
9. Adjust the position of the paper guides to the label width, and return the paper guide lock lever to lock
the paper guide.
Sensor Cover
Paper wound inside.
Lock Lever
Lock Lever
Paper Guide
Free
Lock
Paper Guide Lock Lever
E8-2
ENGLISH VERSION EO1-330020
8. LOADING THE PAPER
Fig. 8-4
Paper Roll
Supply Holder
Fig. 8-5
Fig. 8-6