Rane Seventy-Two MKII Guía De Usuario página 10

Main Menu
To access the main menu, press Shift and View/Menu, or press and hold View/Menu for 4
seconds. The Main Menu contains the following options.
Mixer Settings: Select this option to edit the following settings:
•
Audio Out: Select this option to edit the Main Out, Mic 1 Clean Feed, and Deck Balance
settings.
Note: When Clean Feed is On, the Mic 1 will not pass audio when recording in Serato DJ Pro.
•
Deck Settings: Select this option to edit the Phono 1/2 Sensitivity, Tone XOver 1/2, and
Deck 1/2 Pan settings.
Note: Set Phono Sensitivity to the settings recommended by your cartridge's manufacturer.
•
Filter Setup: Select this option to edit the Deck 1/2 Resonance, the Sampler Resonance, the
cutoff frequency for the LOW position of the filter knobs (Low Pass Min), or the cutoff
frequency for the HI position of the filter knobs (High Pass Max).
•
Pad Setup: Select this option to edit the Pad Sensitivity settings.
•
Headphone Setup: Select this option to edit the headphone Tone setting.
•
Mic 1 Setup: Select this option to edit the amount of feedback for the mic echo (Mic 1 Echo
Fdbk), the mic ducking threshold (Mic 1 Duck Thresh), or the ducking hold time (Mic 1 Duck
Hold).
•
Touch FX Setup: Select this option to edit Button Mode, which determines the function of the
Touch FX button. In Touch FX Mode, which is the default, tapping the button will open the
Touch FX screen. The button LED will be lit solid green at all times. It will be bright when the
Touch FX screen is open and dim when it is not open. In Tap Mode, tapping the button will set
the FX tempo for the deck in focus, and holding Shift while pressing the button will open the
Touch FX screen. The button LED will be unlit except when pressed.
Flex FX: Select this option to view and edit the internal Flex FX settings.
•
Beats Mult.: Select this option to determine the increments by which Flex FX timings can be
adjusted.
In Extended Mode, you can set Flex FX to standard timings ranging from 1/32 to 32 beats
o
as well as dotted and triplet variants of each of these timings.
In Simple Mode, which is the default, you can set Flex FX beats only to standard timings
o
(no triplet or dotted timings).
In No Dotted Mode, the Flex FX beats include standard timings and triplets but no dotted
o
timings.
In No Triplet Mode, the Flex FX beats include standard and dotted timings but no triplets.
o
•
FX List: You can edit any effect listed below the Beats Mult. option.
To add or remove an effect from the list of favorites, tap the circle on the right side of the
o
display. When the circle is green, the effect will be included in the list of Flex FX in Effects
View. When the circle is empty and effect name is grayed out, the effect will no longer
appear in the list.
To adjust the default settings of the internal Flex FX, tap the wrench icon. Any changes made
o
will be saved to the mixer.
10