Troubleshooting; Power Indicator Is Not Lit; Fuse Replacement; No Sound - Rotel RCD-1072 Manual De Instrucciones

Troubleshooting

Most difficulties in audio systems are the result
of incorrect connections, or improper control
settings. If you encounter problems, isolate the
area of the difficulty, check the control settings,
determine the cause of the fault and make the
necessary changes. If you are unable to get
sound from the RCD-1072, refer to the sug-
gestions for the following conditions:

Power Indicator Is Not Lit

The Power Indicator and the basic items in
the Display window should be lit whenever
the RCD-1072 is plugged into the wall power
outlet and the Power button is pushed in. If it
does not light, test the power outlet with another
electrical device, such as a lamp. Be sure the
power outlet being used is not controlled by
a switch that has been turned off.

Fuse Replacement

If another electrical device works when plugged
into the power outlet, but the Power Indicator
and the Display still will not light when the
RCD-1072 is plugged into the wall outlet,
it indicates that the internal power fuse may
have blown. If you believe this has happened,
contact your authorized Rotel dealer to get the
fuse replaced.

No Sound

Check the cables between the RCD-1072 and
the amplifier inputs to be sure they are con-
nected properly. Be sure the amplifier input
that the RCD-1072 is selected. Be sure the
tape monitor system of the amplifier has not
been activated. Check the wiring between the
amplifer and the speakers.
9
Specifications
Total Harmonic Distortion + Noise
Intermodulation Distortion
Frequency Response (± 0.5 dB)
Channel Balance
Phase Linearity
Channel Separation
Signal to Noise Ratio
Dynamic Range
Digital to Analog Converters
Speed Accuracy, Wow & Flutter
Output Impedance
Digital Output
Load Impedance
Power Requirements
USA Version
European Version:
Power Consumption
Dimensions (W, H, D)
Front Panel Height (for rack mount)
Weight (net)
All specifications are accurate at the time of printing. Rotel reserves the right to make improvements without
notice.
Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.
, HDCD ® High Definition Compatible Digital
marks or trademarks of Pacific Microsonics, Inc, in the United States and /or other countries.
0.0045% @ 1kHz
0.0045% @ 1kHz
20-20,000 Hz
± 0.5 dB
± 0.5 degree
> 98 dB @ 1kHz
> 100dB
> 96 dB
18 bit equivalent, multi-level Delta-Sigma DAC with
8x oversampling digital filter and HDCD
Quartz Crystal Precision
100 Ohms
0.5 Volt, Peak to Peak
75 Ohms
AC 120V, 60 Hz
AC 230V, 50 Hz
20 Watts
17 x 3 / x 13 / inches
11 1
16 4
432 x 93 x 337 mm
3 5 / inches, 80 mm
32
5.8 kg, 12.8 lb.
® and Pacific Microsonics™ are either registered trade-