RIGO MRI Manual De Uso Y Mantenimiento página 9

10 SAFETY STANDARDS DURING USE
- The airbrush must not be used in places related to the anti-deflagrating regulation;
- During use the surroundings are to be free of inflammable sources such as flames, smoking cigarettes, sparks, white-hot
cables, over-heated surfaces, etc.;
- During use make sure that there is sufficient airing in the surrounding area and pay attention to the direction of the wind
outdoors.
- The operators must wear the special protective devices during the spraying operations (masks, gloves, protecting
clothing, etc.)
- Use only original spare parts.
Our company declines any responsibility if the above mentioned safety standards are not observed, and is also not
responsible for any incorrect use of the equipment or tempering.
11 STARTING UP
1 Fit the conical pipe union into the handle.
2 Fill the tank with varnish.
3 Adjust the quantity and the finishing level of the covering product according to its density/viscosity by using the adjusting
screw (Figure B ). For the MRS MBA models, operate also on the air faucet placed on the tank cover (Figure
4 It is possible to obtain three different types of spray by rotating the locknut: oval vertical, oval horizontal or round (Figure
5 In order to obtain uniform painting, it is advisable to start the arm movement before activating the distribution lever and
to keep the airbrush perpendicular to the surface to be painted carrying out crossing strokes thus avoiding irregularities
may form on the varnish layer (Figure
12 MAINTENANCE
In order to guarantee the faultless operation of the airbrush during time, cleaning is necessary after usual work to avoid
residues may dry up internally.
For a better cleaning: after using it, pour some clean solvent and suitable for the type of used product inside the tank, shake
the airbrush and spray (repeat this operation at least twice).
DO NOT USE SHARP METAL OBJECTS TO CLEAN POSSIBLE OBSTRUCTED PASSAGE HOLES. THEY
COULD BE DAMAGED THUS REDUCING THE SPRAY QUALITY.
13 RECOMMENDATIONS IN CASE OF OPERATING
Problem
The airbrush sprays in
stroking manner
Jet not uniform
Paint loss from the nozzle
without pulling the lever
Air exit instead of varnish
when pulling the lever
).
E
Probable cause
- Loosened paint nozzle
- Loosened gland
- Incorrect density product
- Dirty or damaged locknut holes
- Stick and nozzle dirty with dried paint
- Stick and nozzle damaged
- Paint passage obstructed
- Air passage obstructed by paint
- Wear and tear of the tank gasket
- 9 -
Solution
- Tighten the nozzle
- Tighten the gland
- Check the covering product density
- Clean the airbrush parts carefully
- Replace the damaged parts
- Clean the airbrush parts carefully
- Replace the damaged parts
- Clean carefully
- Replace the damaged part
EN
C ).
D ).