LD Systems WIN42HUB Manual De Usuario página 21

USINg THE WIN42 CONTROL CENTER SOFTWARE:
The following functions are available in the Environment Scan window (sample depiction of environment scan)
3
2
4 5
SCAN MENU
PORT
1
Select the port of one of the connected receivers that is to be used for scanning. Note: This receiver cannot
be used for any other function during scanning.
START SCAN
2
Starts the scanning procedure. The receiver defined in the port selection is used to scan the environment.
The receiver RF field strength is displayed directly in the graph. The entire procedure may take several
minutes.
If the scanning procedure cannot be started, then the message "Scan timeout" appears. In this case, make
certain that the proper port (1) is selected and the receiver is correctly connected and working.
STOP
3
Stops the scanning procedure.
SAVE PIC
4
Click here to save the scan results as a graphics file (*.jpg) on your computer.
SCAN TABLE
5
Click here to view the scan results in tabular form and allocate unused frequencies to the connected
receivers. See also the section "Scan Table".
SHOW GRID
6
Toggles the coordinate grid in the display on and off.
1
6
7
8
9
21