Operation
WARNING!
Risk of injury!
Handling the laminator improperly may result in injury.
− If an object (sleeves, tie etc.) is unintentionally taken into
the laminating pouch infeed slot, immediately disconnect
the power plug.
NOTICE!
Risk of damage!
Improper handling of the laminator may lead to damage to the
laminator or documents.
− Do not in any case laminate documents with a treated
surface (e.g. fax or thermopaper, Polaroid pictures etc.)
and papers with surfaces that may be altered through
heat (tickets, ultrasonic scans etc.).
− Only use one laminating pouch per lamination, as
laminating pouches may stick tightly together.
− Do not leave any laminating pouches in or next to the
laminator after lamination.
When using the laminator, a slight odour may be produced.
Ensure there is sufficient ventilation in the room, e.g. by opening
windows.
Laminating
1. Move the ON / OFF switch
The ready indicator will turn from dark blue to red within the next
1 ½–2 minutes.
2. Once the ready indicator
sides of the laminating pouch
Make sure that the document is flush with and aligned as close as possible
to the sealed edge of the laminating pouch.
3. Insert the laminating pouch so that it is centered and with the closed-edge
first into the laminating pouch infeed slot
to "ON" (―) (see fig. B).
3
1
is red, place the document between the two
5
.
2
on the back of the laminator.
Operation
13