Removing A Jammed Laminating Pouch; Cleaning - EASYHOME OL 250-L Manual Del Usuario

Cleaning

The heating rollers will automatically pull the laminating pouch in and move
it to the laminating pouch output slot
Don't use force to pull out the laminating pouch.
4. Remove the laminating pouch and let it cool off briefly on a flat surface.
− If necessary, you can cut off excessive material after it has
− Repeat the process if the laminating pouch has not
5. Move the ON / OFF switch to "OFF" ( ) to switch the laminator off.

Removing a jammed laminating pouch

The laminator is equipped with an antiblocking system. If the laminating pouch
was not inserted straight or it becomes jammed in the laminator, proceed as
follows:
1. Move the ABS switch
hold it down (see fig. C).
2. Pull the laminating pouch
It is recommended you pull the laminating pouch out in the
direction of its larger end.
You can place the document in a new laminating pouch and laminate it again.
Cleaning
WARNING!
Burn hazard!
The laminator will become hot during operation. You may burn
yourself.
− Always let the laminator cool off completely before you
clean it.
NOTICE!
Risk of short circuit!
Water that has penetrated the housing may cause a short
circuit.
14
cooled off.
adequately adhered to the document.
6 towards the laminating pouch infeed slot
5
4
on the front of the laminator.
out of the laminator.
2 and