Operation; System Components - Rolair 13GR30HK30 Manual De Instrucciones Y Cuido

PIPING:
The compressed air distribution system should be of sufficient pipe size to keep the pressure drop between
the supply and point of use to a minimum. All piping should be sloped to an accessible drain-point. Outlets should be
taken from top of mainline so that moisture will not enter the outlet.
LUBRICATION:
Prior to daily operation, make a habit of checking the oil level in your compressor pump. A sight gauge on the
outside of the pump's crankcase is provided to make the job easier. Always maintain the oil level to read 2/3 full on
the sight gauge. Oil levels over this amount will result in oil blowing past the rings or out of the crankcase breather.
Lower amounts of oil will result in insufficient lubrication of moving parts.
Reciprocating compressors will consume a certain amount of oil under normal operation. If you are concerned
about your oil consumption, monitor and record oil consumption daily and consult your local dealer. When filling your
crankcase with oil, be sure to use a single viscosity, non-detergent oil.
DO NOT USE A DETERGENT OIL!!
Oil Capacity
(oz.)
Check the oil before starting.
BK119 45
K17 34 Prior to shipping, complete units are filled with oil and tested. The oil should
K18 34
be drained and replaced after an initial break-in period of 50 hours.
K24 61
K28 61 NOTE: Bare pumps are shipped without oil. See reference charts for oil type
K30 47
and capacity.
K35 47
Whether you have purchased a complete unit or bare pump, check the oil level
K50 59
K60 98
and correct if needed before starting each day.
K100 127
Important: Do not over-fill your pump. It will cause harm.
MK103 17
MK113 30
After break-in period, use a single-grade, non-detergent motor oil with foam, rust and oxidation
PT03 24
inhibitors. For maximum performance and service life, we recommend using ROLAIR
PV02 24
compressor oil. (See your oil distributor or representative for compressor oil.)
DO NOT USE DETERGENT OIL!
See chart for oil recommendation in varying temperature conditions.
INSTALLATION
(con't)

OPERATION

SYSTEM COMPONENTS

8
Proper Oil Level:
Premium Quality
®