Pro Breeze PB-H06 Manual De Instrucciones página 7

Setting the Auto-On Timer
1.
Switch the radiator on as per the "Switching On" instructions but do not press the
Standby Button.
2. Press the Timer button. The time digits (H) will blink.
3. Use the "+'' and "-'' buttons to set the desired time (1-24 hours) prior to auto-on.
Between 0-5 hours, time increases by increments of 0.5 hours. Between 5-24
hours, time increases by increments of 1 hour.
4. The time digits will stop blinking and show the remaining time till auto-on.
5. Set the desired mode or temperature prior to auto-on by pressing the Mode button
immediately after the time digits stop blinking and following steps 1-4 under
Mode. If ECO mode is selected, set the desired temperature at time of auto-on by
following steps 1-4 under Thermostat Function.
Note: If no mode or temperature is set when setting an auto-on timer the heater will start
on the Low power setting.
Setting the Auto-Off Timer
1. Whilst the heater is operating press the Timer button. The time digits (H) will blink.
2. Use the "+'' and "-'' buttons to set the desired time (1-24 hours) prior to auto-off.
Between 0-5 hours, time increases by increments of 0.5 hours. Between 5-24
hours, time increases by increments of 1 hour.
3. The time digits will stop blinking and show the remaining time till auto-off.
4. The heater will automatically shut off when the time runs out.
OPERATING THE HEATER USING THE REMOTE CONTROL
- Ensure that the heater is switched to the "I'' ON position at the On/Off switch.
- The remote control functions in the same way as the control panel and should be
used as such.
- The effective range of the remote control is 5m from the radiator and should be
directed towards the front of the radiator when in use.
English | 6