Electrical Connection - Austria Email REU Serie Instrucciones De Uso Y De Montaje

Electrical Connection

• Only qualified specialised personnel may connect the immersion heater to
fixed lines while observing the relevant professional standards and laws.
• A ground fault circuit interrupter with a trip current of I
installed upstream from the electrical circuit.
• The electrical connection is to be carried out exclusively according to the
connection diagram adhered to the inside of the protective cap!
• Before working on the immersion heater, this is to be de-energised, che-
cked for the absence of voltage and secured against being switched on
again.
• If a connection cable is damaged, immediately unplug the power plug and
call a professional!
• Connection cables may not be extended or cut through in any way.
• ATTENTION: The factory wiring must not be altered!
Servicing
• Maintenance, cleaning and any necessary repair or service work may only
be performed by specialised personnel who are qualified for this purpose.
• Never try to fix errors and faults yourself.
• Necessary service and maintenance intervals are to be observed in ac-
cordance with these operating and assembly instructions.
≤ 30mA must be
∆n
| 23
Id.Nr.: 182568-13