Initial Setup - James S32 D1600 Manual Del Usuario

Initial Setup

Initial setup involves selecting all the settings
required to be able to search for and store all
the analogue and digital channels you can
receive.
Make sure that the television is switched on and
Note:
If the channel search retrieved only the
analogue channels it could be caused
by poor broadcasting and therefore is
not coverd by manufacturer warranty.
Manufacturers cannot be held responsible
for lack of or poor broadcasting in some
areas.
Setup wizard opens, which guides you through
the initial setup process. (Refer to Figure 1.)
Environment
Please select your language:
English
Português
Espanol
Figure 1
Step 1: Environment setup
1. Press to select your language, then
press OK to enter the next step.
2. Press to select your conntry, then
press OK to enter the next step.
3. Press to select your location, then
press OK to enter the next step.
Step 2: Network setup
1. P r e s s t o s e l e c t y o u r n e t w o r k
connection type(Wired or wireless), then
press OK to enter the next step.
2. Follow the guides on the screen and press
the corresponding buttons on the remote
control to proceed.
Note:
You can also skip this step and step 3
by selecting "I do not have a network
connection", and connect to the internet
later. For details please refer to section
Network Connection.
2 3 4 5 6
Select Next
11
Connections and Setup
Step 3: Software setup
1. If the set has connected to the network
successfully, it will search for upgrade files
automatically.
2. Follow the guides on the screen and press
the corresponding buttons on the remote
control to proceed.
Step 4: Channel installation
1. Press to select Continue to install
cannels.
2. Follow the guides on the screen and press
the corresponding buttons on the remote
control to proceed.
Note:
To prevent the channel installation process
form being interrupted, wait for the message
indicating that the installation is complete.
You can also skip this step by selecting "I
don't want to install channels".
In this case, to search and store your
channels you may do an automatic channel
search by follwing the instructions in the next
section Performing an automatic channel
search.
Step 5: Clock setup
If the set was not connected to the network, you
can use the numeric buttons to enter the date
and time, then select the OK button and press
OK
When the initial setup is completed, the
Congratulations message appears. Press OK