Rear Panel - Phonic FIREFLY ADA8 Manual De Usuario

Rear Panel

10. AC Power Connector
This is a power receptacle for standard IEC power cables.
Below the connector, users will find a small cover beneath
which they can find the unit's fuse. When a fuse blows,
this cover can be opened to replace the fuse within.
Always use an identical fuse only.
11. ADAT Output
This TOSlink ADAT output will send 8 tracks out to
compatible ADAT input devices. The output signals are
those received via the analog input channels on the front
of the device. The sampling rate for the output can be
either 44.1 or 48 kHz, as determined by the digital master
source (either the Firefly ADA8 or an external device, as
determined by the sync switch).
12. ADAT Input
Connect ADAT output devices to this TOSlink input
connector. This signal received by this connector will
automatically be routed to the 8 analog line output
channels.
FIREFLY ADA8
10
15
11 12 13 14
13. Word Clock Connector
This BNC connector is only activated when then WC
IN option is selected using the Sync Switch. When a
number of digital devices are connected to a digital mixing
console, for example, the word clock signal must be used
to sync all digital devices.
14. Sync Switch
The sync switch has 4 possible positions: WC IN (Word
Clock In), ADAT In, 44.1 kHz and 48 kHz. When set to
WC or ADAT, the Firefly ADA8 will be set to slave – taking
its sample rate from the selected external device. When
the 44.1 kHz and 48 kHz options are selected, the Firefly
ADA8 will act as the master sync source. External devices
should be set to slave. Consult your external product's
user's manual for more information.
15. Line Outputs
There are 8 line-level XLR outputs included on the Firefly
ADA8. The signals sent from these outputs will be the 8
individual signals received via the ADAT input connector.
3