Recording Mode - Monacor SCD-40 Manual De Instrucciones

5 Operation
5.1 Reproducing mode
1) Switch on the TV set/monitor resp. set it to standby mode.
Switch on the audio/video source to be reproduced.
2) TV sets which are not automatically switched over to au-
dio/video operation via the connected additional unit, must
be set to audio/video operation manually (see operating in-
structions of the TV set).
3) To select a connected audio/video source, push the corre-
sponding switch (9).
4) To end the reproduction, switch off the units.

5.2 Recording mode

1) Switch on the units to be used for dubbing. The recording
video recorder at scart jack 1 must be set to recording
mode.
2) For dubbing from the unit at scart jack 2 to the video
recorder at scart jack 1, push the switch 2
For dubbing from the unit at scart jack 3 to the video
recorder at scart jack 1, push the switch 3
3) To end the recording, push the switch OFF (6).
Note: In the recording mode the TV set as well as the record-
ing video recorder are not automatically switched over to au-
dio/video operation. Both units must be set to audio/video
operation manually.
6 Specifications
Inputs: . . . . . . . . . . . . . . . . 3 x scart
Outputs: . . . . . . . . . . . . . . 1 x scart
Dimensions (W x H x D): . . 146 x 50 x 130 mm
Weight: . . . . . . . . . . . . . . . 525 g
According to the manufacturer.
Subject to technical change.
1 x L/R audio, phono
1 (7).
1 (8).
GB
9