Installing / Removing Brush Heads; First Use - Kompernaß KH 107 Instrucciones De Uso

Installing / removing brush heads

Turn the brush head
To install the brush head
The brush head
heads, to avoid damage to the appliance. (For replacement brush heads,
see the order form)

First use

Before operating the appliance, ensure that it is in working condition. If
not, it may not be used.
• Insert the power cord into the wall socket.
• Before the first use, clean the new brush heads
• Place the hand appliance
easily slides into the guides in the plinth.
• Allow the hand appliance
using it for the first time. After the first use, the battery requires only
approximately 12 hours to completely recharge. The display light
on the front of the hand appliance
process.
Notice: If the hand appliance
charging station
care of the batteries if you place the hand appliance
charging station
socket to recharge the hand appliance
toothbrush have noticeably weakened.
clockwise and remove it upwards.
, apply the opposite procedure.
must click in on installation. Only use original brush
into the charging station
to charge up for ca. 24 hours before
is fully charged, remove the plug of the
from the mains power socket. This contributes to the
after every use. Insert the plug into the mains power
glows red during the charging
first when the movements of the
- 27 -
with clear water.
such that it
back into the