During Treatment; After Treatment - Imetec Bellissima Flash&Go Pro Instrucciones De Uso

EN
• Do Not usE tHE appliaNcE oN NipplEs or GENital
orGaNs.
tHE poWEr lEVEl
Select the power level CAREFULLY!
The power level refers to the intensity of the pulse of light that is projected
on the skin and ranges from the lowest to the highest. The power level LEDs
(5D) indicate the set power level.
When the power level increases, the results improve, however, the risk of
side effects also increases (refer to "Possible side effects").
• always start the treatment at the lowest energy level.
• always shave the area that is to be treated and make sure the skin
is clean and dry before using the appliance.
The best results are achieved 1-2 days after shaving, when the hairs are 1-2
mm long.
Only if you feel little or no discomfort during and after use with the power
level set to the lowest can you increase the power by one level, and so forth
until you reach the maximum level suitable for your skin type. For detailed
instructions regarding the power level, refer to "Power Level" in "Information
before use".
• On your face, if there are few and thin dark hairs to be treated, it is not
necessary to shave the area, only trim them shorter with scissors. If the
hairs are very short (approximately 1-2 mm) and not too thick, there is no
need to shave nor trim them.
• cover any birthmark and tattoos before using the appliance.
• cover dark brown or black spots, such as large freckles, a
42
birthmark, moles or warts before using the appliance.
• Do Not use flammable liquids, such as alcohol, products
containing alcohol (including perfume, sanitary products, etc.) or
acetone to clean the skin before using the appliance.
tHE patcH tEst
It is recommended to perform a patch test before starting treatment, in
order to identify the maximum tolerance of your skin to light pulses. Refer to
"Information before use" for instructions regarding the patch test.

DuriNG trEatmENt

WarNiNG! aVoiD treating the same skin area more
than once or overlapping skin areas.
WarNiNG! Do Not overlap pulses.
• if the skin blisters or burns, stop usE immEDiatElY.
• Ensure that the treatment surface is pointed towards the skin, and
is completely in contact with it.
• remove the treatment surface from the skin if the skin or the
treatment surface become excessively hot.

aFtEr trEatmENt

• After treatment it is possible to apply an alcohol and perfume-free, gentle or
EN
43