Preparing The Appliance - Imetec Bellissima Flash&Go Pro Instrucciones De Uso

EN
WarNiNG! carefully read all warnings and safety
precautions, possible adverse reactions, treatment
areas and epilation programme.

prEpariNG tHE appliaNcE

1. Remove the appliance and the other components from the package.
2. If the appliance is stored in a very cold place, wait for it to reach at least 15 °C.
3. If the plug has not been inserted into the power supply unit (7),
hold the power supply unit, pull the "Open" key downwards and
insert the plug (7A, 7B or 7C) which is suitable for the socket of
the electrical system, into the relative slot.
4. Insert the cable of the plug (7) into the power supply connection (3).
5. Insert the plug (7) into a socket: all the LEDs on the control
panel (5) will go on and off autonomously.
WarNiNG! Do Not use this appliance if there are visible
signs of damage.
trEatmENt
6. Press the power level setting and on/off button (5A): the yellow power level 1
LED (5d) lights up and the ventilation system is activated (you will hear a sound
similar to that of a hair dryer).
7. About 1 second after having pressed the power level setting and on/off button
54
usE
(5a), the device ready-for-use LED (5C) lights up: the appliance is automatically
set to the lowest power level.
8. Set the energy level that you wish to use for the treatment. To set the energy level,
follow the directions provided in the 'Information before use' chapter.
9. Apply the treatment surface (2) firmly on the skin. Only when the treatment surface
(2) is entirely in contact with the skin will the skin device ready-for-use LED (5c)
start to flash slowly.
10. The appliance automatically checks the colour of the skin, then emits a light pulse
accompanied by an acoustic signal similar to a snap. A slight tingling and warm
sensation may be felt. Stop using the appliance immediately if excessive heat or
tingling is felt or blisters or small burns appear on the skin.
11. Select the application mode to continue the treatment.
By pulse method
11A.Remove the treatment surface (2) from the skin. The appliance is recharged
immediately for the next pulse. After a few seconds (depending on the set power
level), the device ready-for-use LED (5C) lights up. Apply the treatment surface (2)
on a new section of the skin: the device ready-for-use LED (5C) starts flashing slowly
and the appliance emits a new impulse. Use the pressure marks left previously to
place the treatment surface on the adjacent section, avoiding overlapped pulses
(See "Covering the entire treatment area").
11A.Repeat the process until the entire area to be treated is covered.
sliding method
11B.Keep the treatment surface (2) in contact with the skin and slide the device in a
slow gliding motion while remaining in contact with the skin, along the area to be
treated. The recharging time between pulses allows for an uninterrupted sequence
EN
55