DELTACALOR 750 W Manual De Usuario página 38

Installation and RF
Initialisation rules
Install and connect the receiver respecting
the following guidelines to guarantee an op-
timal reception:
• The receiver must be mounted at a mini-
mum distance of 50cm of all others elec-
trical or wireless materials like GSM, Wi-Fi
router.
• Wiring work related to the receiver must
be carried out only when de-energized.
• Connect your receiver to the power sup-
ply.
Depending on your installation, an or-
der of pairing must be respected to en-
sure a correct RF signal transmission.
Installation 1:
Receiver + RF thermostat
1. Switch on the receiver.
2. Press the RF button during 5 sec to
switch to RF Init.
3. The RF LED should be Green fixed or
orange blink indicating that the Receiv-
er is now in radio configuration mode
waiting for a thermostat configuration
address.
4. Please refer to the thermostat leaflet for
enter the thermostat in "RF Init" mode.
5. The receiver RF LED must be switched
OFF and the thermostat should exit the
RF init mode to indicate correct paring
between both elements.
You can pair several receivers to the same RF
thermostats.
Note for installations 2 and 3 - You can
pair several receivers. Pay attention! Before link-
ing a new receiver with the Central unit, you have
to reset the receiverimperatively.
Installation 2:
Receiver + RF Thermostat + RF Central
unit for heating regulation
1. First step is to pair the RF thermostat to
the Central unit.
2. Press the RF button on the receiver dur-
ing 5sec.
3. The RF LED should be Green fixed or
orange blink indicating that the Receiver
is now in radio configuration mode wait-
ing for a central configuration address.
4. Please refer to the leaflet of the Cen-
tral unit for more explanation about the
pairing mode "RF Init". You must pair the
Receiver as a heating device in the Cen-
tral unit.
5. The RF LED on the receiver will switch
OFF and the Central will show a mes-
sage to indicate correct pairing between
both elements.
You can pair several receivers in the same
room.
Installation 3:
Installation 3: Receiver + RF Central
unit for ON/OFF or light control
1. Press the RF Button 5sec to switch the
Receiver in RF Init mode.
2. The RF LED should be Green fixed or
orange blink indicating that the Receiver
is now in radio configuration mode wait-
ing for a central configuration address.
3. Please refer to the leaflet of the Cen-
tral unit for more explanation about the
pairing mode "RF Init". You must pair the
Receiver as an ON/OFF plug or a light in
the Central unit.
4. The RF LED on the receiver will switch
OFF and the Central will show a mes-
sage to indicate correct pairing between
both elements.È possibile accoppiare più
ricevitori nella stessa stanza. Il ricevitore
funzionerà in modalità Timer; l'utente ha
la possibilità di configurare un program-
[ EN - 38 ]