Instructions
p
lacing the antenna
In this case the antenna ends in a metal tube, which can be anchored to a tower or foundation
For 2nd place the antenna definitely rooftop roof or a remote location.
toe rotor. This done, the electrical connection must be made by opening the connection box
with screw hole and snap a three-wire hose (you can use the power cable for phase, neutral and
ground, are very cheap and quality optimized) a minim section to 0.5 mm, for 20 meters and 1.5
mm section for a longer distance. It support a consumption of 1 A at 5 volts.
As is unused making quick connect external connector, it is advisable to seal this orifice, with fat
paste used in child labor (No use ordinary silicone is corrosive)
INAC Electrónica para radiocomunicaciones
Tel. +34 976 322 822
Instrucciones
Two ways to use:
1st To use the antenna in a place near or inside a
home, a windowsill balcony.
This arrangement is temporary, and of course, is with the inten-
tion of traveling to places of entertainment, for business travel,
vacation or second home where there is no stable installation of
radio antennas.
To do this, use only the control cable we provide, and insert it in
two sockets of the junction box and the remote antenna. In turn
the control cable has at its ends for inserting plugs and adjustable
pressure by a guide flange. (Do not force the insertion, and may
enter the connector in the wrong position)
And finally, connect a coaxial cable similar length of 50 Ohm
connectors PL.
The antenna to be placed in a vertical position, you can use
the terrace umbrella bases are heavy material, or plastic
to fill with water, equipped with handles, with a hole to in-
sert the pole of the umbrella, in our case, can directly enter
the mast, but it is advisable to extend a little as 1.25 m, su-
perfie away From the ground, as this often leads wrought
iron lattice, for it using a single mast aluminum or wood.
P.O. 3101
http://inac-radio.com e-mail: inac@inac-radio
Gebrauchs
50080 Zaragoza
España
Instructions
Pág.: 10